Energy-saving lamp has been eliminated, the era of LED corn light coming

At present, the energy-saving lamps is consumer daily the most widely used incandescent lamp replacement.Its efficiency is five times higher than the incandescent light bulb, the average life expectancy is about 8000 hours, mature technology, with lights, lamps and lanterns is good match, is a simple and relatively low cost of replacement options.However, energy saving and environmental protection should bring out the best in each other, but in the energy-saving lamps, and both have reached the opposite, the problem of mercury doomed energy-saving lamps will eventually be replaced fate: a common energy-saving lamps, on average, 0.5 mg of mercury content, these can cause about 180 tons of mercury in the underground water pollution.If waste handling, energy-saving lamps in is likely to be "ecological killer", and used energy-saving lamps have been mishandled "good" for many years, even now there is still no appropriate policies and measures.

LED corn bulb using low voltage LED source, LED light source of semiconductor dot longer service life, high efficiency, energy saving, environmental protection and so on "the theory of advantage" has passed the test of practice, all performance parameters of the LED light source is not used to say "improvement", but "in further improving",  the development of LED corn light as a whole outlook is generally positive.

As the incandescent light bulb phase-out and state subsidies on energy saving lighting products, LED corn bulb market has been accelerated the tentacles of LED corn light household lighting is also gradually into the market, In the trend of transforming traditional lighting to LED lighting, some manufacturer in market competition inevitably be eliminated, but also some based on the technical stability and development, after all, any new industry must stand the test of the market to mature in a point of view, it is also a process experienced by any kind of traditional light source, the traditional lighting and LED lighting is a representative of the different stages of development, the rapid development of LED industry, the government vigorously promote, Traditional household lighting lamps and lantern has been eliminated, the era of LED corn light coming.

Comments

Post a Comment

Popular posts from this blog

The advantage of new style TEK LED panel light is obvious

Image
TEK  LED panel light , continue to use the reflective surface luminous technology, light after secondary reflection through high light transmittance mask projection, reduce glare, the light is more soft and comfortable to the human eye to watch not easy fatigue, particularly for students who have long time exposure to indoor lighting lighting, subway passengers or office staff. The application of the patented reflective material ensures the reflection efficiency of the light, and the original high light effect of the panel light is retained to the maximum extent. In order to guarantee the reliability of the use,   the design principle of TEK LED panel light  adhering to the "maintenance", improve heat dissipation performance, reduce the LED light failure of lights and lanterns, significantly prolong the service life of the lights and lanterns, saving the maintenance cost of lights and lanterns. TEK LED panel light is more intelligent TEK LED panel light can form a
Read more

What ways can see LED street lights to replace the high pressure sodium lamp?

Image
Under the condition of current technology,luminous efficiency of  LED street lamp  is more than high pressure sodium lamp, it is an indisputable fact that TEK LED street lamp can reach 160 LM/W. And HPS spectrum is concentrated in the yellow area, its color temperature is low, only 2000-2500 k, and relatively high color temperature such as LED, LED street light natural white temperature of 4000-5000 k, cold white is 5000-6500 k. At the same time compared with HPS, LED street lamp with high color rendering index, close to natural light in the actual lighting, can bring a person the sense of comfort. Followed by "irradiation uniformity", although the  LED street lamp  lighting is relatively concentrated, but can be by the light path of the second design, can make the light source of lamps and lanterns presents the ideal state, realize the reasonable light distribution curve adjustment, control the distribution of light, so as to realize the uniformity of illumination.
Read more

Rule of thumb: what are the installation instructions of DALI LED high bay light?

Image
DALI LED high bay light , also known as LED warehouse light, mainly used in factory workshop, warehouse, exhibition hall, etc., have gradually entered homes, because it is using the latest LED lighting energy saving technology, high reflectivity, high power, high utilization rate of light source. But good lamps and lanterns need specification installation, to highlight its advantages, below for everyone to explain the DALI LED high bay light installation: 1，Define DALI LED high bay light installation height according to the lighting environment, because the environment will change the reflection efficiency of lamps and lanterns. Usually the height of DALI LED high bay light  should be above 5 meters, thread is not close to the lamp shell. If installation height is less than 3 meters, protective measures must be taken to prevent a vehicle to touch. 2，TEK DALI LED high bay light protection class is IP65, choose waterproof transformer, chip packaging place with high temperature resi
Read more